1. OPERATIONAL OVERVIEW
1-69
1.37.15 How to offset the colors for multicolored trail (B/W-type only)
You can “shift” the order of the trail colors. When this function is active, the first color
used to paint the trail is changed.
Note: If the trail time set at the [TRAIL] box is longer than the time selected at [4 TRAIL
LENGTH] in the [TRAIL] menu, trails are not displayed after the trail time elapses. For
example, based on the above figure, if the trail time is set to [05:00] at the [TRAIL] box
and [4 TRIAL LENGTH] is set to [12H], the trail coloration will stop after Yellow.
To offset the colors, follow the procedure below.
1. Open the menu.
2. Select [1 ECHO].
3. Select [0 NEXT].
4. Select [4 TRAILS]. The [TRAILS] menu appears.
Note: You can also right-click the [TRAIL] box to access this menu.
5. Select [0 NEXT] to show the second page of the menu.
6. Select [6 LONG TRAIL COLOR].
7. Select [2 OFFSET TRAIL COLOR].
8. To offset the color by one, select [ON].
For example, if you selected [FUSCHIA] as the starting color for multicolor trails,
the first color after the offset becomes [MAROON].
To leave the colors in their original order, select [OFF].
9. Close the menu.
Target echo
Fuschia
coloration
starts here
Fuschia Maroon Red Magenta Yellow
Maroon Red Magenta Yellow Lime
Echo trail
Echo trail
Trail coloration before
offset is applied
Trail coloration after
offset is applied
To Next Page
Loading...
Need help?
General
