Furuno TZT2BB - Safety Instructions

i
SAFETY INSTRUCTIONS
WARNING
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Warning, Caution
Mandatory Action
Prohibitive Action
The installer must read the applicable safety instructions before attempting to install or
operate the equipment.
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment
unless totally familiar with
electrical circuits.
Only qualified personnel are
permitted to work inside the
equipment.
Turn off the power at the
switchboard before beginning
the installation.
Fire or electrical shock can result
if the power is left on.
CAUTION
Be sure to use the designated
power supply and cables.
Use of incorrect power supply or
cables can cause fire or damage
the equipment.
Install a control unit (or emer-
gency stop button) at each helm
station, to allow you to disable
the autopilot in an emergency.
If the autopilot cannot be disabled,
accidents may result.
Use the proper fuse.
Use of an incorrect fuse may
damage the equipment.
Observe the following compass safe
distances to prevent interference to
a magnetic compass:
Standard
compass
MPU-004
MCU-005
PSD-003
Steering
compass
0.50 m
0.30 m
0.35 m 0.30 m
0.55 m 0.40 m
Model
Ground the equipment to prevent
electrical shock and mutual
interference.