3. EQUIPMENT SETUP
3-6
3.3 Initial Setup
This section shows you how to set your system according to the sensors you have
connected.
Note 1: Some units are set to metric in this section, actual setting ranges vary
depending on the unit of measurement set in the [Units] menu.
Note 2: For configurations using the DFF-3D, refer to the instructions outlined in the
operator’s manual (OME-13520-xx; xx indicates publication version).
1. Tap the [FURUNO] icon ( ) to show the home screen and display
mode settings.
2. Tap [Settings] to show the [Settings] menu.
3. Drag the main menu, then tap [Initial Setup] to show the [Initial Setup] menu.
4. Referring to the tables on the following pages, set your equipment.
[GPS POSITION] menu
[BOAT INFORMATION] menu
Menu item Description Options (setting range)
[Longitudinal (from
bow]
Referring to the figure on the
right, enter the GPS antenna
positioning bow-stern
(Longitudinal) and
port-starboard (Lateral)
position from the origin.
0 (m) to 999 (m)
[Lateral (-Port)] -99 (m) to +99 (m)
Port-side is negative,
Starboard-side is positive.
Menu item Description Options (setting range)
[Boat Length] Set the length of your boat. 0 (m) to 999 (m)
[Boat MMSI] Set your boat’s MMSI. Max. 9 characters
[Boat Name] Set your boat’s name. Max. 32 characters
[Size of Own Ship Icon] Set the size of own ship icon. 50 to 150
[Depth Display] Select the start point for depth measure-
ment.
[Under Keel],
[Under Sea Level]
[External Transducer
Draft]
Set the draft external transducers other
than internal fish finder, networked or
multi-beam sonar.
For internal/network transducers, set
the draft from Home screen[Set-
tings][Sounder][Transducer Draft].
For multi-beam sonars, set the draft
from Home screen[Settings][Multi-
beam Sonar][Initial Setup][External
Transducer Draft].
0.0 (m) to 99.9 (m)
[Keel Draft] Set the keel draft. 0.0 (m) to 99.9 (m
[Engine Count] Set the number of engines. 0 to 6
To Next Page
Loading...
Need help?
General