Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 46
Program Number Time Temp Power
Pad 01 1 minute 3 secs Off 100%
Pad 02 3 minutes Off 100%
59 minutes 59secs 480 °F None
Pad 04
Stage 1 30 minutes 480 °F 100%
29 minutes 59 secs 480 °F 50%
Pad 03
Stage 2
1 With the oven switched off hold down the CANCEL ( ANNULER ) Pad and switch the oven
ON, the display shows the current Menukey Code, continue to hold the CANCEL
( ANNULER ) Pad for approximately 10 seconds until the display shows
EE 00:00
indicating the oven is now in engineering mode
2 Programs will be set as follows:
APPENDIX 1
Tim Hortons variants: Power Test and Microwave Leakage Test (Pages 22-24)
Engineering Mode programs
In order to carry out the Power Test and Microwave Leakage Test on Tim Hortons variant
Ovens, the Icon Pad programs on the control panel need to be switched to Engineering
Program Mode.
Engineering Mode does not affect the current Menukey program settings for the Icon pads
and the current Menukey programs are automatically restored when the oven is next
switched on.
To switch to Engineering Mode Programs:
All other programs will be blank
3 Follow the Leakage Check Procedure as detailed on pages 22-23, using Program 01 ( Cake )
to give the required 1 minute 3 seconds at 100% Microwave Power setting.
4 Follow the Power test procedure as detailed on Page 24 using Program Pad 01 ( Cake) to
give the required 1 minute 3 seconds at 100% Microwave Power setting.
5 On completion the current Menukey programs are automatically restored when the oven is
next switched on.
To Next Page
Loading...
Need help?
General
