Turning Your GPSMAP 278 On or Off
Before you turn on the GPSMAP 278, be sure the antenna is rotated
up as shown on page 1, and it has a clear and unobstructed view of
the sky to receive satellite signals.
The first time you turn on your GPSMAP 278, the GPS receiver
must collect satellite data and establish its current location. To
ensure proper initialization, the GPSMAP 278 is shipped from the
factory in AutoLocate mode, which allows the receiver to “find
itself” anywhere in the world.
To turn the GPSMAP 278 on and off:
1. Press and hold the
POWER key. When the unit turns on,
a tone sounds and the Warning Page appears.
Warning Page
2. Read the warning, and then press ENTER to continue.
3. To turn off the GPSMAP 278, press and hold the
POWER key again.
Adjusting the Backlight and Volume
You can adjust the backlight to see the display better. If you are
using the External Speaker with 12/24-Volt Adapter Cable with the
GPSMAP 278, you can adjust the volume level of the audio output.
To adjust the backlight level or volume:
1. Press and quickly release the
POWER key.
2. Press up on the ROCKER to increase the brightness or
press down to decrease. Press right to raise the volume or
left to lower.
3. Press ENTER or QUIT to close the Backlight/Volume
adjustment window.
Backlight
adjustment slider
Volume
adjustment slider
Battery time remaining and power source indicator
GPSMAP 278 Owner’s Manual 3
GETTING STARTED > TURNING YOUR GPSMAP 278 ON OR OFF AND ADJUSTING THE BACKLIGHT AND VOLUME
To Next Page
Loading...
Need help?
General
