GE HEALTHCARE PROPRIETARY TO GE
D
IRECTION 5394227, 12 LOGIQ S8/LOGIQ E8 SERVICE MANUAL
Section 3-11 - Connectivity Setup 3 - 69
3-11-6 Wired Ethernet from LOGIQ S8 to a Workstation
3-11-6-1 Direct Connection from the LS8 to a WS via a Crossover Cable
You only need a Crossover Cable for network use to connect the two units this way.
1.) Connect one end of the crossed network cable to the network connector on the LOGIQ S8.
2.) Connect the other end to the network connector to the Workstation, see the Workstation Service
Manual.
3-11-6-2 Connection via a Peer-to-Peer Network
You will need a network switch and one network cable for each unit connected to the switch.
3-11-6-3 Connection via Hospital Network
You will need one network cable to connect the LOGIQ S8 to a wall outlet on the hospital’s network.
3-11-7 Connection using Wireless Option (R2.x.x or later)
Refer to:
- 8-35-5 "Wireless LAN Set-up" on page 8-297.
- Chapter 5 for theory.
- Basic User Manual: Chapter 10 Configuring Connectivity.
To Next Page
Loading...
Need help?
General
