GE LOGIQ S8 User Manual

GE HEALTHCARE
DIRECTION 5394227, 12 LOGIQ S8/LOGIQ E8 SERVICE MANUAL
7 - 76 Section 7-7 - Troubleshooting Trees, Instructions and Tech Tips
7-7-11 Extended Battery Option Trouble Shooting
Table 7-15 Extended Battery Option Trouble Shooting
Fault symptom Check these items
Cannot go to Off line scanning
mode (system shutdown)
System Error during Off-line
scanning mode
Make sure Software version is R4 or later.
Also Make sure if remaining Capacity is enough (capacity can be checked by clicking Battery-
Icon on Main-display)
Cannot go to Off line scanning
mode
(unintentionally go to Power
Assistant mode)
Make sure if “Always “is not selected on the following check box (Utility=>setting=>General).
Note: LOGIQ S8/E8 R4 does not support Off-line-scanning function on PowerAssistant Option.
Make sure if Battery Remaining Capacity is enough (if battery remaining capacity is quite low,
system automatically go to Power saving mode)
Cannot use Printer
Cannot use Universal Video
Converter
This is system spec.
AC-powered modules cannot be used on Battery-mode.
Short battery life(less than 60
minutes)
Replace all of 4 batteries.
Battery operation time depends on the console configuration and scanning mode.
Beep sound starts while
discharging
This is system spec.
If “Battery Low Warning with Sound” checkbox (Utility=>setting=>General) is checked, the
system plays a beep sound when the battery capacity is low.
Battery charge takes long time
This is system spec.
It will take over 8 hours to complete charging of Extended battery (from empty, new batteries).
MAIN FAN starts operation after
shutting down system.
This is system spec.
From CPS3SB, “Battery-charging on Stand-by” function supported.
MAIN-FAN continues operating during charge. After fully-charged, MAIN-FAN automatically
stops.
This function is available for both of PowerAssistant and Extended-battery R4 and later.

GE LOGIQ S8 Specifications

General

Brand	GE
Model	LOGIQ S8
Category	Medical Equipment
Language	English