Introduction
1-20 LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10
Battery Safety
To avoid the risk of injury, follow the warning and cautions to
make sure that the battery does not burst, ignite, or generate
heat of fumes.
• The battery has a safety device. Do not disassemble or
alter the battery.
• Charge and discharge the batteries only when the ambient
temperature is between 10° and 40° C (50° F and 104° F).
• Do not short-circuit the battery by directly connecting the
negative terminals with metal objects.
• Do not heat the battery or discard it in a fire.
• Do not expose the battery to temperature over 50° C
(122° F). Keep it away from fire and other heat sources.
• Do not charge the battery near a heat source, such as a
fire or heater.
• Do not leave the battery in direct sunlight.
• Do not drop packs from height to prevent them from
possible malfunction damage.
• Do not drop packs from height to prevent them from
possible malfunction damage.
• Do not pierce the battery with a sharp object, hit it, or step
on it.
• Do not use a damaged battery.
• Do not solder a battery.
• Do not connect the battery to an electrical power outlet.
• Do not contact PCM (Power Control and Monitor, it’s a
small board in the battery) directly to prevent packs from
ESD damage.
• In case of longer non-use of the LOGIQ V2/LOGIQ V1,
please make sure the battery is removed.
To Next Page
Loading...
Need help?
General
