5. Push forward and rotate the battery downward until it seats beneath the rear
battery compartment latch.
Caution: Do not connect the battery until you are ready to power up the panel.
Figure 10: Battery installation
Pb
Applying AC power
Make sure the outlet is not controlled by a switch or that it is not part of a ground
fault circuit interrupt (GFCI).
1. Remove the center screw from the outlet cover plate and hold the cover plate in
place.
WARNING: Use extreme caution when securing the transformer to a metal outlet
cover. You could receive a serious shock if a metal outlet cover drops down onto the
prongs of the plug.
2. Plug the transformer into the lower receptacle of the outlet so that the hole in the
transformer tab lines up with the outlet cover screw hole.
3. Insert the cover plate screw through the transformer tab and the outlet cover
plate. Tighten the screw.
20 Simon XT Installation Manual
To Next Page
Loading...
Need help?
General
