Arming
level
Description Indication
2 Arm doors and windows. Two beeps verify that door/window sensors are
armed. The panel displays
DOORS+WINDOWS
and speaks Doors and Windows On. The
Doors+Windows button lights.
3 Arm motion sensors. Three beeps verify that motion sensors are armed.
The panel displays Motions and speaks
Motions On. The Motions button lights.
4 Arm doors, windows, and motion
sensors.
Four beeps verify that door/window and motion
sensors are armed. The panel displays
DOORS+WINDOWS & MOTIONS and
speaks Doors and Windows On, Motion On. The
Doors+Windows and Motions buttons light.
Sensors
Test the sensors after all programming is completed and whenever a sensor-related
problem occurs.
Note: While the sensor test is a valuable installation and service tool, it only tests
sensor operation for the current conditions. You should perform a sensor test after
any change in environment, equipment, or programming.
Notify the central station you will be performing a test prior to starting the test.
To test the sensors:
1. Place all sensors in their secured (no alarm) state.
2. Scroll to Sensor Test options under the System Tests menu, and then press OK.
The panel will prompt you to trip each sensor one at a time. You may follow the
panel prompting or test the sensors in any order. See the Table 27 on page 45 for
specific instructions on how to trip each sensor type.
Interior sirens sound transmission beeps, and the display identifies the tripped
sensor and the number of RF packets received. The system will continue to
prompt for sensors that have not yet been tested. When all sensors have been
tested, the display shows SN Test Complete Press Status.
3. Press Status. The display shows Sensor Test OK.
If you press Status and the panel has not heard from all sensors, the displays
shows SN Test Fail or Aborted.
44 Simon XT Installation Manual
To Next Page
Loading...
Need help?
General
