Table 29: Sensor/user report codes
Arm or disarm from Reports as user
Panel or remote handheld touchpad 0
Key fob 1 to 40 (sensor number)
Panel auxiliary panic 41
Panel tamper 42
Panel police panic 43
Panel fire panic 44
Dealer access code 44
Installer access code 45
Master code 46
Access codes 1 to 8 47 to 54
Duress code 55
Two-way voice operation
For the central station operator to initiate an audio session:
1. After the panel has completed reporting the alarm, pick up the CS phone and
press the * button to start the audio session.
2. Press 1 or 0 to speak, 2 for VOX operation, and 3 or 6 to listen.
3. Press 99 to terminate the session.
Note: Panel voice announcements are silenced during AVM sessions. If the operator
does not terminate the session correctly, panel announcements may not occur for up
to 90 seconds after the operator hangs up.
Table 30: Audio verification set
Phone button Function
0 or 1 Speak
2 VOX operation
3 or 6 Listen
7 Extend session for 90 more seconds
88 Terminates session with call back (the panel answers on
the first ring if called within 5 minutes)
99 Terminates session with no call back
48 Simon XT Installation Manual
To Next Page
Loading...
Need help?
General
