Use the following steps as a guideline only and always refer to the instructions
supplied with the de-scaling agents regarding dosage and de-scaling time.
1. Switch off the machine and open the door. Remove all canisters and back
covers.
2. Using the drain hose fitted to the tank, remove the bung and drain the
water from the heater into a suitable water tight container.
Safety First! Allow the water in the tank to cool before draining.
3. Once all of the water has drained from the tank, replace the bung into the
drain hose. Introduce the de-scaling solution in the recommended dosage
into the heater tank. Switch on the machine and allow the heater tank to
fill.
4. Turn off the machine and leave for approximately 40 minutes before
draining the tank again following the sequence described above.
5. Fit a new water filter and switch on the machine. Fill the tank and drain
again until all traces of the de-scaler are removed (at least 3 times).
6. Switch on the machine and allow the heater tank to fill and to heat up.
Drain and fill one more time. The machine is now ready to be put back in
service.
12.3 Brewer Maintenance (Freshbrew Machines)
Freshbrew machines are fitted with a dual brewer unit which produces freshbrew
coffee and tea beverages from the same unit. Routine cleaning and maintenance
instructions for this unit can be found in the Genesis Operators Manual - Part No.
PR1035001.
12.3.1 Removing The Brewer
Periodically it may be necessary to remove the brewer from the machine.
1. Open the door and insert the safety key. The machine is now on.
2. Using the service keypad (see page 69) mounted inside the door, press
Brewer Open (
button 2). The brewer will index to its fully open position
and stop. Remove the safety key to turn the power off. Remove the
brewer guard to gain access to the brewer unit.
3. Carefully remove both the coffee and tea water inlet pipes from the
brewer. Remove the dispense pipe from the tea brewer and dispense pipe
complete with outlet adaptor from the coffee brewer. Pull down the
spring loaded brewer release pin and carefully remove the brewer unit
from its locating bracket.
Technical Manual
122
To Next Page
Loading...
Need help?
General
