Section 4 - Engineers Program
To access the Engineers Program, enter the
programming mode as described in Section 3. Once
in the Engineers Program the LCD on the front of
the machine will display the top level programming
menu screen - Main Menu.
N.B. Coins In/Out will only be displayed on
machines fitted with an MDB coin mech.
Using the ▲ (up) or ▼ (down) keys, ↵ (Edit) key and X (Exit) key on the drink
selection keypad the engineer can navigate quickly and easily through the engineers
program menus as described in Section 3 -
Programming Mode (see page 18).
4.1 Data Recall Menu
Entry into this menu allows the engineer to view
Non-Resettable and Resettable Sales Data, view data
relating to Timed Events and Identification Numbers
of installed components and (if feature enabled) view
SureVend™ assisted vend information. The Re-
settable Sales Data and SureVend™ data menus
contain an extra sub-menu which allows the engineer to delete the current data
from the machines memory.
4.1.1 Non Resettable Sales Data
This menu allows the engineer to view and record monetary and sales values.
This data cannot be reset and will remain intact for the service life of the
controller board (unless the back-up battery is removed).
1. From the Data Recall screen highlight Non
Resettable Sales Data and press the ↵
(Edit) key. The LCD will display the screen
as shown opposite. From this menu the
engineer can view data for the Overall
Totals (highlighted), By Product, along with
data relating to Cash, Cashless and Token Vends.
2. To view the Overall Totals screen, press the ↵ (Edit) key on the drink
selection keypad. This menu displays both the total £ amount and total
vend counts for the following data:
Technical Manual
22
To Next Page
Loading...
Need help?
General
