5.7 Button 7 - Cup Test
This button enables the operator to test the operation of the cup drop unit after
refilling the cup stacks. When the button is pressed the cup drop solenoid is
operated and a cup is ejected from the cup drop unit. This function ensures that the
mechanism is working correctly.
5.8 Button 8 - Park Head
When this button is pressed, the dispense head moves to its fully extended position
and stops. Press the button again to return the dispense head to its correct (homed)
position.
N.B. It is necessary for the operator to wait for a few seconds between each key
press to allow the machine to respond accordingly.
5.9 Button 9 - Boiler Fill (B2C Machines)
When this button is pressed, the machine pumps a measured amount of water
through the system - approximately 400ml, heating it as it does so. This ensures that
heated water is immediately available when a drink is selected. This button should
also be used to purge any water left in the system after the machine has been
moved or shut down for any length of time.
5.10 Button 10 - Machine Cool Down (B2C Machines)
This button enables an engineer to work safely on the water system and should not
be used by the operator.
5.11 Button 11 - CoEx® Tablet Clean (B2C Machines)
This button initiates the CoEx® brewer tablet cleaning routine. CMS recommends
that this brewer cleaning routine should be carried out on a weekly basis.
During the cleaning routine the LCD displays the message ‘Cleaning in progress’.
5.12 Button 12 - Reset Waste Counter (FB & B2C Machines)
Every time that the brewer waste container is emptied the waste counter must be
reset. Press button 12 on the service keypad to reset the counter. Two audible
bleeps confirm that the counter has been reset to zero.
5.13 Button 13 -
This button is not currently used in the Genesis machine.
5.14 Button 14 - Clear SureVend™ Error
This button enables the operator to simply and quickly clear SureVend™ errors
caused by cup failures.
Technical Manual
72
To Next Page
Loading...
Need help?
General
