4.8 System Settings Menu
This menu allows the engineer to input text
information relevant to the machine and its location,
set the current time and date, change the language
displayed, configure the monetary system, set and
view DTS information, backup and restore machine
software, view the machine and I/O board software
versions installed in the machine, set temperature
and idle screen display options and input custom
messages.
N.B. Serial Flash sub menu is only visible when a
Serial Flash card (see page 58) is inserted into plug
J9A on the control board.
4.8.1 Machine Information
This sub-menu allows the engineer to create a unique identification for the
machine and enter its location. A combination of text and numerical data can
be entered and stored via the machines keypad.
1. From the Systems Settings menu highlight
Machine Information and press the ↵
(Edit) key. The LCD will display the
screen as shown opposite. To update/
create a Machine ID press the ↵ (Edit)
key.
2. Enter a machine ID using the 0-9 drink selection keys. Press the relevant
key until the required letter/number is highlighted. To correct an input
error press the 0 key once. To add a space between characters, press the
0 key twice.
The keys are configured as follows:
1 = , . ? ' ; : " 1
2 = a b c 2
3 = d e f 3
4 = g h i 4
5 = j k l 5
6 = m n o 6
7 = p q r s 7
8 = t u v 8
9 = w x y z 9
0 = - \ $ @ % # & 0
N.B. To change from lower to upper case, press the START/? key.
Technical Manual
48
To Next Page
Loading...
Need help?
General
