45
Mixed draft and position mode
adjustment
This operating mode is ideal for jobs
carried out in draft control mode on
irregular ground when the implement is
liable to dig too deeply into the soil.
Dig the implement into the ground down to
the desired depth as described for the draft
control mode.
Once the required depth has been
reached, gradually move lever A back
towards the end of travel point until the lift
links begin to slightly raise.
The power lift will operate in the draft
control mode but will stop the implement
from digging too deeply into the soil if it
encounters softer ground. This prevents
the tillage work from becoming irregular.
Only use lever A to raise and dig in the
implement.
Regulating lift rate and sensitivity
Slacken off completely regulating
screw, to lock the implement in its
raised position. This is a safety device
when implements are transported on
road.
Screw out this regulator to increase lift
lowering speed.
3-point hitch sensitivity can be further
increases by attaching it to one of the lower
tractor hitch holes.
To Next Page
Loading...
Need help?
General
