5 - Operation
64
Safety Precautions - Crop Protection Chemicals
±
WARNING! Always be careful when working with crop protection chemicals!
±
WARNING! Always wear proper protective clothing before handling chemicals!
Personal protection
Depending on chemical type, protective gear/equipment should be worn to avoid contact with the chemicals, such as:
• Gloves
• Waterproof boots
• Headgear
• Respirator
• Safety goggles
• Chemical resistant overall
±
WARNING! Protective clothing/equipment should be used when preparing the spray liquid, during the spray job and
when cleaning the sprayer. Follow the chemical manufacturer’s instructions given on the chemical label.
±
WARNING! It is always advisable to have clean water available, especially when filling the sprayer with chemicals.
±
WARNING! Always clean the sprayer carefully and immediately after use.
±
WARNING! Only mix chemicals in the tank according to directions given by the chemical manufacturer.
±
WARNING! Always clean the sprayer before changing to another chemical.
Filling Chemicals Through Tank Lid
The chemicals are filled through the tank lid - Note instructions on the chemical container!
±
WARNING! Be careful not to slip or splash chemicals when carrying chemicals up to the tank lid!
1. Make sure the spray control unit is switched off.
2. Set suction SmartValve towards “Suction from main tank”,
Agitation valve towards “Agitation” and pressure SmartValve
towards “Spraying”.
3. Engage the pump and set P.T.O. revolutions to recommended
pump r.p.m.
4. Add the chemicals through the main tank hole.
5. Keep P.T.O. engaged so the spray liquid is continuously agitated
until it has been sprayed on the crop.
To Next Page
Loading...
Need help?
General
