6 - Maintenance
88
50 Hours Service - Greasing the pump
When operating the pump, it MUST be greased every 50 hours with 1 oz.
(30 grams) grease into each lubrication point.
ATTENTION! In order to avoid excessive wear, it is important to
use a recommended lubricant (i.e. HARDI® part no. 28164600).
See “Recommended lubricants” on page 81.
ATTENTION! The pump MUST be stopped during greasing!
50 Hours Service - Transmission Shaft (P.T.O.)
1. Check function and condition of the transmission shaft protection guard. Replace any damaged parts.
2. Lubrication. See “Lubrication & Oiling Plan - Trailer/ParaLift™” on page 82.
3. See the manufacturer’s instruction book.
50 Hours Service - Wheel nuts
Tighten wheel nuts as follows with following torque wrench settings:
Wheel hub to rim plate: 250 Ft/lb (340 Nm)
Tightening sequence: See illustration and tighten in order of
numbering.
50 Hours Service - Tire Pressure
Check the tire pressure according to the table “Tire Pressure” on page 107.
€
DANGER! Never inflate tires more than to the pressure specified in the table. Over-inflated tires can explode and cause
severe personal injuries!
±
WARNING! If replacing tires, always use tires with min. load index as specified.
250 Hours Service - Hydraulic circuit
Check the hydraulic circuit for leaks and repair if any.
±
WARNING! Hoses for boom lifting device must be changed after every 5 years of use.
To Next Page
Loading...
Need help?
General
