AB2200en_SARev.: 04 / 11.2023
Transport conditions
3.7 Scope of supply
The following accessories are supplied with the centrifuge:
■
1 hex key (SW5x100)
■ 1 power cable
■
1 user manual
■
1 instruction sheet, transport lock
Rotors and the corresponding accessories are supplied depending on the
order.
3.8
Returns
An original Return Material Authorisation (RMA) form from the manufacturer
must always be requested for a return. Secure and reliable acceptance and
booking in of the goods with the manufacturer is not possible without an
original RMA form from the manufacturer. The Return Material Authorisation
(RMA) form contains a Declaration of No Objection (UBE), which must be
completed in full and enclosed with the return.
If the device and/or accessories are returned to the manufacturer, the
complete return shipment must be cleaned and decontaminated by the
sender. If returns are not cleaned and/or decontaminated or are insuf-
ciently cleaned and/or decontaminated, this will be performed by the manu-
facturer and charged to the sender.
The original transport locks must be attached for return shipment, see
⮫
Chapter 4 ‘Transport and storage’ on page 16
. The device must be
shipped in its original packaging.
4
Transport and storage
4.1
Transport and storage conditions
NOTICE
Damage to the device due to failure to use the transport
locks.
− Secure the transport locks before transporting the
device.
NOTICE
Damage to the device due to condensation.
There is a risk of condensation forming on electrical com-
ponents when component surfaces are cold and the sur-
rounding air is warmer. The condensation that forms may
cause a short circuit and/or destroy electronics.
− Warm the device up for at least 3 hours in a warm room
before connecting it to the mains.
or
−
Warm up for 30 minutes in a cold room.
■ Before transporting, fasten the transport lock and disconnect the device
from the mains socket.
■ The transport temperature must be between -20°Cand+60°C.
To Next Page
Loading...
Need help?
General
