As per requirements defined in EN 50131-1:2006+A1:2009+A2:2017+A3:2020
AX Pro wireless control panel adopts pass-through mode of acknowledgement
operation. Both positive and negative acknowledgement from the transceiver of
receiving center will be recorded.
AX Pro wireless control panel is compatible with SIA IP Reporting (UDP/TCP-2013) as per
ANSI/SIA DC-09-2013: Internet Protocol Event Reporting. The control panel supports
tokens (protocols) of ADM-CID and SIA-DCS defined in SIA DC-07-2001.04, which will be
modified to insert a “*” before token name as *ADM-CID and *SIA-DCS when the data
and timestamp of transmission message are AES encrypted. AES-128, AES-192 and AES-
256 are all supported.
Note
ISUP5.0:
A privacy internet protocol that is used for accessing the third-party platform, which supports
alarm report uploading, AX PRO management, and short video uploading.
The prioritization of the message and indications are the same. The AXPRO uploads messages
and gives indications synchronously.
Standard DC-09 Protocol:
– ADM-CID: The data presenting method of DC-09 is CID, which is not encrypted and only for
uploading alarm report.
– *ADC-CID: The data presenting method of DC-09 is CID, which is encrypted and only for
uploading alarm report.
– SIA-DCS: The data presenting method of DC-09 is DCS (also called SIA protocol), which is
not encrypted and only for uploading alarm report.
– *SIA-DCS: The data presenting method of DC-09 is DCS (also called SIA protocol), which is
encrypted and only for uploading alarm report.
To Next Page
Loading...
Need help?
General
