To Next Page

To Previous Page

If the lost card is added in one access group and the access group is applied to the device

already, aer reporng card loss or cancelling card loss, a window will pop up to nofy you to

apply the changes to the device. Aer applying to device, these changes can take eect on the

device.

7.4.6 Set Card Issuing Parameters

The client provides two modes for reading a card's number: via card enrollment staon or via the

card reader of the access control device. If a card enrollment staon is available, connect it to the

PC running the client by USB interface or COM, and place the card on the card enrollment to read

the card number. If not, you can also swipe the card on the card reader of the added access control

device to get the card number. As a result, before issuing a card to one person, you need to set the

card issuing parameters including the issuing mode and related parameters.

When adding a card to one person, click

Sengs to open the Card Issuing Sengs window.

Local Mode: Issue Card by Card Enrollment

Staon

Connect a card enrollment staon to the PC running the client. You can place the card on the card

enrollment

staon to get the card number.

Card Enrollment Staon

Select the model of the connected card enrollment staon

Note

Currently, the supported card enrollment staon models include DS-K1F100-D8, DS-K1F100-M,

DS-K1F100-D8E, and DS-K1F180-D8E.

Card Type

This eld is only available when the model is DS-K1F100-D8E or DS-K1F180-D8E.

Select the card type as EM card or IC card according to the actual card type.

Serial Port

It is only available when the model is DS-K1F100-M.

Select the COM the card enrollment

staon connects to.

Buzzing

Enable or disable the buzzing when the card number is read successfully.

Card No. Type

Select the type of the card number according to actual needs.

M1 Card Encrypon

This eld is only available when the model is DS-K1F100-D8, DS-K1F100-D8E, or DS-K1F180-D8E.

If the card is M1 card, and if you need to enable the M1 Card

Encrypon funcon, you should

enable this funcon and select the sector of the card to encrypt.

DS-K3G200(L)X Series Tripod Turnsle

HIKVISION DS-K3G200LX-R/Dm55 User Manual

Questions and Answers: