iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 50
4. Select the detection target. Human and Vehicle are available. If the detection target is not selected, all
detected targets will be reported, including humans and vehicles.
Figure 6-7 Set Rule
5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
7. Click Save.
Set Unattended Baggage Detection
Use to detect objects left in a pre-defined region. Linkage methods can be triggered if an object is left
and stays in the region for a set time period.
Steps
1. Go to Configuration → Event → Smart Event → Unattended Baggage Detection.
2. Check Enable.
3. Select one Region. For the detection region settings, refer to Draw Area.
4. Set rules.
• Sensitivity: Percentage of body part of an acceptable target that enters a pre-defined region.
Sensitivity = 100 - S1/ST × 100. S1 is the target body part that crosses the pre-defined region. ST is
the complete target body. The higher the sensitivity value, the more easily the alarm is triggered.
• Threshold: The time of the objects left in the region. Alarm is triggered if the object is left and stays
in the region for the set time period.
To Next Page
Loading...
Need help?
General
