iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 58
• By Browser: Enter the domain name in the browser address bar to access the device.
• By Client Software: Add domain name to the client software. Refer to the client manual for specific
adding methods.
Access to Device via PPPoE Dial Up Connection
This device supports the PPPoE auto dial-up function. The device gets a public IP address by ADSL dial-up
after the device is connected to a modem. You need to configure the PPPoE parameters of the device.
Steps
1. Go to Configuration → Network → Basic Settings → PPPoE.
2. Check Enable PPPoE.
3. Set the PPPoE parameters.
• Dynamic IP: After successful dial-up, the dynamic IP address of the WAN is displayed.
• User Name: User name for dial-up network access.
• Password: Password for dial-up network access.
• Confirm: Input your dial-up password again.
4. Click Save.
5. Access the device.
• By Browsers: Enter the WAN dynamic IP address in the browser address bar to access the device.
• By Client Software: Add the WAN dynamic IP address to the client software. Refer to the client
manual for details.
The obtained IP address is dynamically assigned via PPPoE, so the IP address always
changes after rebooting the camera. To solve the inconvenience of the dynamic IP, you
need to get a domain name from the DDNS provider (e.g., DynDns.com). Refer to Access to
Device via Domain Name for detailed information.
Wireless Dial
Data of audio, video, and image can be transferred via a 3G/4G wireless network.
The function is supported only by certain device models.
To Next Page
Loading...
Need help?
General
