iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 70
Set E-mail
When the e-mail is configured and Send Email is enabled as a linkage method, the device sends an e-mail
notification to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the E-mail function. Go to Configuration → Network → Basic Settings →
TCP/IP for DNS settings.
Steps
1. Go to e-mail settings page: Configuration → Network → Advanced Settings → Email.
2. Set e-mail parameters.
1) Input the sender’s e-mail information, including the Sender’s Address, SMTP Server, and SMTP Port.
2) Optional: If your e-mail server requires authentication, check Authentication and input your user
name and password to log in to the server.
3) Set the E-mail Encryption.
• When you select SSL or TLS, and disable STARTTLS, emails are sent after encrypted by SSL or
TLS. The SMTP port should be set as 465.
• When you select SSL or TLS and Enable STARTTLS, emails are sent after encrypted by STARTTLS,
and the SMTP port should be set as 25.
If you want to use STARTTLS, make sure that the protocol is supported by your e-mail server.
If you check the Enable STARTTLS while the protocol is not supported by your e-mail sever,
your e-mail is sent with no encryption.
4) Optional: If you want to receive notification with alarm pictures, check Attached Image. The
notification email has three attached alarm pictures about the event with configurable image
capturing interval.
5) Input the receiver’s information, including the receiver’s name and address.
6) Click Test to see if the function is well configured.
3. Click Save.
Notify Surveillance Center
Check Notify Surveillance Center, the alarm information is uploaded to the surveillance center when an
alarm event is detected.
Trigger Recording
Check Trigger Recording, and the device records the video about the detected alarm event. For recording
settings, refer to Video Recording and Picture Capture.
To Next Page
Loading...
Need help?
General
