iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 95
Set Regional People Queuing-Up
Use to count queuing-up persons in defined regions. Alarms are triggered when the alarm threshold
condition and the alarm trigger are both met.
Before You Start
To enable the function, go to VCA Resource, and select Queue Management.
Steps
1. Go to Configuration → Queue Management.
2. Select Regional People Queuing-Up.
3. Click Add Region to draw the detection area and set Region Name and Alarm Interval. Repeat this step
above to set more areas.
• Alarm Interval: During the set alarm interval, alarms of the same type only trigger one notification.
Figure 10-2 Set Regional People Queuing-Up
4. Optional: Check OSD to display the region name and its real-time queuing-up people number.
5. Set Alarm threshold. An alarm is triggered when the alarm threshold condition is met.
6. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings, refer
to Linkage Method Settings.
7. Click Save.
Set Waiting Time Detection
It is used to count the waiting time of each person that enters the detection area. Alarms are triggered
when the alarm threshold condition and the alarm trigger are both met.
Before You Start
To enable the function, go to VCA Resource, and select Queue Management.
To Next Page
Loading...
Need help?
General
