HIKVISION iDS-TCM403-A User Manual

10.9 Debug
Note
The debug conguraons below are only provided to debug the device by the professionals.
10.9.1 Debug Device
You can enable the funcons to debug the device.
Steps
1.
Go to Conguraon → Capture → Advanced → System Service .
2.
Check the debug
informaon according to your needs.
Enable Algorithm POS Informaon Debug
The algorithm POS informaon will be overlaid on the playback image when you play back
the video with the dedicated tool.
Enable Posioning Frame Debug
The posioning frames of vehicle bodies and license plates will be overlaid on the captured
pictures.
Enable Closed
Posioning Frame
The boom lines of the posioning frames on the captured pictures will display. The frames
will be closed.
Enable LPR Area Frame
The LPR area frames on the captured pictures will display.
Note
The funcon is only valid in the trigger modes of checkpoint single I/O and RS-485 radar, and
manual capture. In these modes, the license plate may not be included in the LPR area, and
the LPR rate is low. To solve the problem, you can enable the funcon to add a green frame
on the captured picture to check whether the license plate is included in the LPR area.
LPR Area Frame Y-Direcon Deviaon: Up-, Down+
If the license plate is not included in the LPR area frame, adjust the LPR area frame posion in
the
Y-direcon by pixel. Enter the deviaon pixel in the text eld. The value = image height ×
(deviaon distance/100). Set the value according to the actual needs. Range: -100% to 100%.
The LPR area frame moves up if the value is negave, and it moves down if the value is
posive.
3.
Click Save.
Network Trac Camera Operaon Manual
51

HIKVISION iDS-TCM403-A Specifications

General

Brand	HIKVISION
Model	iDS-TCM403-A
Category	Security Camera
Language	English