HIKVISION iDS-TCM403-A User Manual

Enter IPv6 Address, IPv6 Subnet Mask, and IPv6 Gateway. Consult the network
administrator for required informaon.
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that
can be communicated in a single network layer
transacon.
The valid value range of MTU is 1280 to 1500.
Mulcast
Mulcast
is group communicaon where data transmission is addressed to a group of
desnaon devices simultaneously. Aer seng the IP address of the mulcast host, you can
send the source data
eciently to mulple receivers.
Router
Enter Route Address and Subnet Mask if the device is connected to a router in mul-network
isolaon mode.
DNS
It stands for domain name server. It is required if you need to visit the device with domain
name. And it is also required for some
applicaons (e.g., sending email). Set Preferred DNS
Address properly if needed.
4.
Click Save.
6.2 Connect to
Plaorm
6.2.1 Connect to ISUP Plaorm
ISUP (EHome) is a plaorm access protocol. The device can be remotely accessed via this plaorm.
Before You Start
●
Create the device ID on ISUP
plaorm.
●
Ensure the device can communicate with the plaorm normally.
Steps
1.
Go to Conguraon → Network → Data Connecon → ISUP .
Network Trac Camera Operaon Manual
33

HIKVISION iDS-TCM403-A Specifications

General

Brand	HIKVISION
Model	iDS-TCM403-A
Category	Security Camera
Language	English