1 Local Operatio
1.1
Acti ate Indoor Statio
You can only configu e and operate the indoor statio afte creatin a password for
the device acti ation
Steps
1.
Power on the device. It will enter the acti atio page automati ally.
2.
Cr
eate a password and confir it.
3.
T
ap OK to
acti ate the indoor station
Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 char
acters, including at least three kinds of following
categories: upper case lette s, lower case lette s, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, resetti the password monthly or weekly can bette protect your
product.
1.2 Configu atio Settin
Configu atio settin is required before startin using the indoor station It is
necessar
y to set the indoor statio network, room No., linked devices, device tim
display, and so on.
1.2.1 Set Indoor Statio Network Parameters
Network connectio is mandatory for the use of the indoor station Set the network
parameters afte acti atin the indoor station Only when the IP address of the
indoor statio is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor statio is 192.0.0.64.
Network Indoor Statio Configu atio Guide
1
To Next Page
Loading...
Need help?
General
