Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
T
ap Settin →
→
Configu atio →
t
o enter the network settin page.
Note
Default admin password is 888999.
Figure 1-2 Network Settin
2.
Enable DHCP, then the indoor statio can search and get an IP address
automati ally.
Note
Skip the following steps if you have enabled DHCP.
3.
Se
t the IP address manually.
1.2.2 Set SIP Server
A SIP server connectio is required and necessary for the indoor statio to guarantee
the
connectio between the indoor statio and the management center (master
station in the same video intercom system. 2 types of SIP protocol are available for
the indoor station Private Protocol, and Standard Protocol.
Network Indoor Statio Configu atio Guide
2
To Next Page
Need help?
General
