4 VersaCare® Bed User Manual (161956 REV 2)
Standard Features
Emergency CPR
When activated, the CPR release decouples the head section actuator so that the head
section may lower to the horizontal position. This function is gas-assisted to cushion the
movement and can be used when power is not available. If a treatment/therapy surface is
installed and the bed has AC power, the surface will go into Max-Inflate to support a CPR
board. After 30 minutes of Max-Inflate, the surface will go into Normal mode.
The surface will not go into Max-Inflate if the bed is being powered by the battery back-
up.
The emergency CPR controls are handles located under
the sleep deck, between the head and intermediate
siderails on both sides of the bed. The headboard can be
used as a CPR board.
To Activate
1. Pull and hold the handle.
2. Hold the handle until the head and knee sections
come to a stop in the flat position and the foot section stops raising.
There must be power to the bed for the knee and foot sections to operate.
3. Release the handle.
During activation, releasing the CPR control handle will cause the head section to stop
lowering.
The head section actuator is automatically re-enabled after the CPR control handle is
released.
Emergency Trendelenburg
The emergency Trendelenburg allows the head end of the bed to lower to a maximum
inclination of 15°.
The emergency Trendelenburg controls are handles
located under the sleep deck, between the head and
intermediate siderails on both sides of the bed. They are
the same controls as the emergency CPR.
The emergency Trendelenburg control works only when
the bed is connected to AC power or when battery power
is enabled.
To Next Page
Loading...
Need help?
General
