48 VersaCare® Bed User Manual (161956 REV 2)
Patient Helper Adapter Bracket
(P844G01/02) and (P3212A)
The patient helper adapter bracket
(P844G01) is for use with patient helper
sleeves from traction equipment
manufacturers.
The patient helper sleeve (P3212A) must be
installed before the adapter bracket is
installed on the bed. Refer to the equipment
manufacturer’s instructions for installation
procedures. The P3212A patient helper
sleeve is for use with the Orthopedic Systems, Inc. patient helper.
The P844G02 is for Canadian applications.
When installed, these accessories will add
length to the bed as follows:
• P844G01 adds 2.25" (5.72 cm)
• P844G01 with the P3212A installed
adds 4.25" (10.80 cm)
• P844G02 adds 4.25" (10.80 cm)
Do not exceed the load capacity of the Patient Helper Adapter Bracket. If the
Patient Helper Adapter Bracket is overloaded, personal injury or equipment
damage could occur.
The safe working load of the Patient Helper Adapter Bracket is 200 lb (90 kg).
Permanent IV Pole (P2222A)
The Permanent IV Pole option consists of one IV pole that
supports up to two IV pumps plus bags. The IV pole is attached
to the bed frame near the corner of the headboard. The IV pole
can support up to 40 lb (18 kg).
This IV Pole is recommended for beds that will be used in
Progressive Care or Step Down settings.
Do not exceed the 40 lb (18 kg) IV pole weight capacity.
To Next Page
Loading...
Need help?
General
