Hitachi Advanced Server HA820 G2 User Guide 77
Installing persistent memory modules
Use this procedure only for new persistent memory module installations. If you are migrating this persistent memory module
from another server, see the Persistent Memory User Guide on the
Hitachi Vantara website
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
The components included with the hardware option kit
•
A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1.
Observe the following alerts:
CAUTION:
DIMMs and persistent memory modules are keyed for proper alignment. Align notches on
the DIMM or persistent memory module with the corresponding notches in the slot before installing
the component. Do not force the DIMM or persistent memory module into the slot. When installed
properly, not all DIMMs or persistent memory modules will face in the same direction.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you are properly
grounded before beginning this procedure.
CAUTION:
Failure to properly handle persistent memory modules can damage the component and the
system board connector.
IMPORTANT:
Hitachi Vantara recommends that you implement best-practice configurations suchas
clustered configurations for high availability (HA).
2.
Power down the server Power down the server
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
a.
Extend the server from the rack Extending the server from the rack.
b.
Remove the server from the rack Removing the server from the rack.
5.
Place the server on a flat, level work surface.
6.
Remove the access panel.
To Next Page
Loading...
Need help?
General