Hitachi Advanced Server HA820 G2 User Guide 96
Secondary riser connector
PCIe slot and card
length
3-slot riser* 2-slot riser (Optional) 2-slot riser (Optional)
Slot 4 - Full-
length/Full-height
(FL/FH)
PCIe3 x8 (8, 4, 2, 1) — PCIe3 x16 (16, 8, 4, 2, 1)
Slot 5 - Full-length/Full-
height (FL/FH)
PCIe3 x16 (16, 8, 4, 2,
1)
PCIe3 x16 (16, 8, 4, 2, 1) PCIe3 x16 (16, 8, 4, 2, 1)
Slot 6 - Half-length/Full-
height (HL/FH)
PCIe3 x8 (8, 4, 2, 1) PCIe3 x16 (16, 8, 4, 2, 1) —
*The server ships with one PCIe3 riser cage installed in the primary riser cage connector.
Tertiary riser connector
PCIe slot and card length 2-slot riser (Optional) 1-slot riser (Optional)
Slot 7 - Full-length/Full-height
(FL/FH)
PCIe3 x8 (8, 4, 2, 1) PCIe3 x16 (16, 8, 4, 2, 1)
Slot 8 - Half-length/Full-height
(HL/FH)
Installing expansion boards
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the
power cord to remove power from the server. The front panel Power On/Standby button does not shut off
system power. Portions of the power supply and some internal circuitry remain active until AC power is
removed.
CAUTION:
To prevent improper cooling or thermal damage, do not operate the server unless all PCI slots
have either an expansion slot cover or an expansion board installed.
To install the component:
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure
1.
Power down the server.
2.
Remove all power:
To Next Page
Loading...
Need help?
General