Hitachi YUTAKI S Series Installation And Operation Manual

43
PMEN0643 rev.0 - 04/2023
6
TERMINALBOARDCONNECTIONS
ELECTRICAL AND CONTROL SETTINGS
6.4.2.3 Input terminals (Default input funcons)
◆ Room thermostat communicaon cables
There are two dierent room thermostat types as accessory
Oponal wireless intelligent room thermostat (TB2) ATW-RTU
Only for wireless room thermostat accessory: the receiver is connected to the polarity‑free
terminals 1 and 2.
The Wireless room thermostat and the Intelligent receiver are already congured to communicate
with each other. If the Wireless room thermostat or the Intelligent receiver is replaced or an
addional second temperature circuit thermostat is added, it is necessary to rebind them as
explained in the manual of the Wireless intelligent room thermostat.
The Intelligent receiver is connected to the indoor unit table board as shown in the next picture:
1 2
1
2
H‑LINK
ATW‑RTU
◆ PC-ARFH2E connecon
In cases where another PC‑ARFH2E must be connected as a second thermostat, the connecons
between PC‑ARFH2E and the indoor unit must be done in terminals 3 and 4 and the connecon of the
power supply in terminals 28‑29, as it is shown in the next picture:
3 4
A B
RCS H‑LINK
(PC‑ARFH2E)
OK

Hitachi YUTAKI S Series Specifications

General

Brand	Hitachi
Model	YUTAKI S Series
Category	Heat Pump
Language	English