HOLOPLOT X1 User Manual

26X1 MD80-S Manual 1.0 en Power Setup and Requirements
AC POWER OUT (GRAY)
The gray AC Power OUT connector on the Electronics
Package can be used to supply power to the subwoofer
amplier module of the MD80-S, which is integrated
within the Loudspeaker Cabinet.
In order to power both the Electronics Package and the
subwoofer amplier module from a single power source
(at AC Input voltages equal or higher than 208 V), connect
the AC Power OUT of the Audio Module to the AC Power IN
on the connector panel of the Loudspeaker Cabinet.
AC Power Out cannot be used with AC input voltages
lower than 208 V. Instead, connect a separate power
source to the AC Power IN on the connector panel of the
Loudspeaker Cabinet.
i
For this purpose, a dedicated AC
Amphenol HP-3-FGJ to Amphenol
HP-3-FJ interconnecting cable is
available from HOLOPLOT as an
accessory (P/N: H42-120-50-B1).
Only use the AC Power OUT at AC
input voltages equal to or higher than
208 V to prevent electrical hazards
!
K
R
O
W
T
E
N
Secondary
Uplink
Secondary
Downlink
Primary
Downlink
Primary
Uplink
K
N
I
L
O
L
O
H
A
B
1
2
K
N
I
L
B
U
S
N
I
Do not connect
under load
T
U
O
AC Output:
240V
~
9.5A
208V
~
9A
AC Input Range:
115-240V
50-60Hz
AC Input:
115V
~
6.5A
240V
~
12.8A
AC Input Range:
115–240 V
50–60 Hz
AC Input:
115 V
~
1.1 A
240 V
~
0.9 A
Do not connect
under load
Only power from
Electronics Package
at Power IN ≥ 208 V
SUBLINK
IN
K
N
I
L
O
L
O
H
A
B
1
2
K
N
I
L
B
U
S
N
I
Do not connect
under load
T
U
O
AC Output:
240V
~
9.5A
208V
~
9A
AC Input Range:
115-240V
50-60Hz
AC Input:
115V
~
6.5A
240V
~
12.8A
AC Input Range:
115–240 V
50–60 Hz
AC Input:
115 V
~
1.1 A
240 V
~
0.9 A
Do not connect
under load
Only power from
Electronics Package
at Power IN ≥ 208 V
SUBLINK
IN
If Power IN ≥ 208 V AC
If Power IN < 208 V AC

HOLOPLOT X1 Specifications

General

Brand	HOLOPLOT
Model	X1
Category	Speaker System
Language	English