Starting the Engine
Start your engine using the following
procedure, regardless of whether the engine
is cold or warm.
NOTICE
• If the engine does not start within 5 seconds,
turn the ignition switch to the (Off)
position and wait 10 seconds before trying to
start the engine again to recover battery
voltage.
•
Extended fast idling and revving the engine can
damage the engine, and the exhaust system.
a
Make sure the engine stop switch is in the
(Run) position.
b
Turn the ignition switch to the (On)
position.
c
Shift the transmission to Neutral (
N
indicator to come on). Alternatively, pull in
the clutch lever to start your motorcycle with
the transmission in gear so long as the side
stand is raised.
d
With the throttle completery closed, press
the start button.
u
If you cannot start the engine, open the
throttle slightly (about 3 mm (0.1 in), without
freeplay) and press the start button.
20171012170126_32K98B000_eng_BOOK Page 48 Thursday, October 12 2017 17:09:26 JST
Operation Guide
45
Continued
About 3 mm (0.1 in), without
freeplay
To Next Page
Loading...
Need help?
General
