Honda CLICK125 User Manual

Brakes
Checking the Front Brake Fluid
1. Place your vehicle in an upright position
on a firm, level surface.
2. Check that the brake fluid reservoir is
horizontal and that the fluid level is above
the LWR level mark.
If the brake fluid reservoir is below the LWR
level mark or if the brake lever freeplay
becomes excessive, inspect the brake pads
for wear.
If the brake pads are not worn, you most
likely have a leak. Have your vehicle
inspected by your dealer.
20221206110820_32K2VD000_eng_BOOK Page 92 Tuesday, December 06 2022 11:12:16 JST
Maintenance
89
LWR mark
Front brake fluid
reservoir

Honda CLICK125 Specifications

General

Fuel System	PGM-FI (Programmed Fuel Injection)
Starter System	Electric
Front Suspension	Telescopic Fork
Rear Brake	Mechanical Leading Trailing
Front Tire	80/90-14
Rear Tire	90/90-14
Seat Height	769 mm
Curb Weight	111 kg
Bore x Stroke	52.4 x 57.9 mm
Compression Ratio	11.0:1
Ignition System	Full Transistorized
Frame Type	Underbone
Wheelbase	1, 280 mm
Ground Clearance	132 mm
Max Torque	10.8 Nm @ 5, 000 rpm
Engine Type	4-stroke, SOHC
Transmission	V-Matic
Front Brake	Hydraulic Disc
Fuel Tank Capacity	5.5 liters
Max Power	8.3 kW @ 8, 500 rpm