Honda CRF230F 2017 User Manual

32
CRF230F
(1) Choke lever
(A) Fully ON
(B) Halfway position
(C) Fully OFF
(A)
(B)
(C)
(1)
Starting the Engine
Always follow the proper starting procedure described
below.
This motorcycle can be started with the transmission
in gear by disengaging the clutch before operating
the starter.
Your motorcycle’s exhaust contains poisonous carbon
monoxide gas. High levels of carbon monoxide can
collect rapidly in enclosed areas such as a garage.
Do not run the engine with the garage door closed.
Even with the door open, run the engine only long
enough to move your motorcycle out of the garage.
Do not use the electric starter for more than 5 seconds
at a time. Release the start button for approximately
10 seconds before pressing it again.
Preparation
Before starting, insert the key and turn the ignition
switch ON.
Make sure that the transmission is in neutral. Turn
the fuel valve ON.
Starting Procedure
To restart a warm engine, follow the procedure for
“High Air Temperature.”
To start a cold engine, follow the procedure for
‘‘Normal Air Temperature.’’
Normal air temperature: 10° – 35°C (50° – 95°F)
1. Pull the choke lever (1) up all the way to Fully ON
(A).

Honda CRF230F 2017 Specifications

General

Engine Type	223cc air-cooled single-cylinder four-stroke
Bore and Stroke	65.5mm x 66.2mm
Compression Ratio	9.0:1
Ignition	CDI
Rear Suspension	Pro-Link Showa single shock; 9.0 inches travel
Front Brake	Single 240mm disc
Rear Brake	Drum
Front Tire	80/100-21
Rear Tire	100/100-18
Curb Weight	249 pounds
Final Drive	Chain
Front Suspension	37mm leading-axle Showa fork
Trail	4.4 inches
Induction	Keihin 26mm piston-valve carburetor