30
OPERATION
AC OPERATION
If an appliance begins to operate abnormally, becomes sluggish, or
stops suddenly, turn it off immediately. Disconnect the appliance, and
determine whether the problem is in the appliance or the rated load
capacity of the generator has been exceeded.
Substantial overloading may damage the generator. Marginal
overloading may shorten the service life of the generator.
1. Turn the voltage selector switch to either position.
With the voltage selector switch in the ‘‘120V/240V’’ position, you
can use the 120V and 120V/240V receptacles simultaneously. If you
are NOT using 240 volts, then select the ‘‘120V ONLY’’ position.
Disconnect or turn OFF all appliances or tools connected to the
generator before changing the voltage selector switch position.
The generator may be damaged if the switch position is changed with
loads connected and operating.
2. Start the engine (see page 23).
VOLTAGE SELECTOR SWITCH
120 V/240 V
120 V ONLY
31Z306120.book 30 ページ ２０１５年１１月２７日 金曜日 午前１０時２５分
To Next Page
Loading...
Need help?
General
