Honda HRN216VKAA User Manual

10-7
HRN216 CAMSHAFT/CRANKSHAFT/ PISTON/CYLINDER
4. CYLINDER HEAD DISASSEMBLY/ ASSEMBLY
Remove the cylinder (P. 1 0- 4 ).
Note
Rocker arm and push rod removal does not require cylinder removal.
After assembly, readjust the valve clearance (P. 3-15
).
VALVE SPRING RETAINER (2)
Push down and slide the retainer to the
side, so the valve stem slips through the
hole at the slide of the retainer.
REMOVAL:
Do not remove the valve spring retainers
while the piston is installed, or the valves
will drop into the cylinder.
8 N•m (5.9 ft-lb)
VALVE ADJUSTING
LOCK NUT (2)
VALVE STEM SEAL
(Intake valve only)
VALVE
SPRING (2)
INTAKE VALVE
EXHAUST VALVE
ROCKER ARM (2)
ROCKER ARM SHAFT (2)
VALVE ADJUSTING SCREW (2)
PUSH ROD (2)
SPARK PLUG
INSTALLATION:
Install each rocker
arm shaft in the
direction as shown.
INSTALLATION:
The intake and
exhaust valves are
the same. However,
if the valves are
being reused,
reinstall them in their
original locations.
INSTALLATION:
The intake and
exhaust valves are
the same. However,
if the valves are
being reused,
reinstall them in their
original locations.
REMOVAL:
Rotate the crankshaft
to top dead center of
the compression
stroke before
removing the rocker
arms.

Honda HRN216VKAA Specifications

General

Brand	Honda
Model	HRN216VKAA
Category	Lawn Mower
Language	English