Honda HRN216VKCA User Manual

10-20
CAMSHAFT/CRANKSHAFT/ PISTON/CYLINDER HRN216
8. PISTON/CONNECTING ROD DISASSEMBLY/ASSEMBLY
Remove the piston/connecting rod (P. 1 0 - 20 ).
ASSEMBLY:
ASSEMBLY:
SIDE RAIL
SPACER
SECOND RING
120°
120°
120°
10 mm (0.4 in)
10 mm
(0.4 in)
PISTON PIN
PISTON
CUTOUT
CLIP
Do not align the end gap of the clip with the
cutout in the piston pin bore.
·
Install by setting one end of the clip in the
piston groove, holding the other end with
long-nosed pliers, and rotating the clip in.
·
PISTON PIN CLIP (2)
ASSEMBLY:
Chrome plated. Do not
interchange with the
SECOND RING.
TOP RING
OIL RING
(COMBINATION RING)
SECOND RING
MANUFACTURERS MARK
Install with the manufacturers mark facing
upward as shown.
·
Do not interchange the top ring and the
second ring.
·
After assembly, check for smooth
movement of the piston rings.
·
Stagger the piston ring end gaps 120°
apart.
·
Do not align the piston end gaps with the
piston pin.
·
PISTON RINGS
TOP RING
(chrome plated)
OIL RING (COMBINATION
RING)
CONNECTING ROD
The connecting rod can be
installed in either direction
during reassembly.

Honda HRN216VKCA Specifications

General

Brand	Honda
Model	HRN216VKCA
Category	Lawn Mower
Language	English