To Next Page

To Previous Page

7 - 38

UPC/EAN Version

Scan the

UPC/EAN Version On

bar code to decode GS1 Composite symbols

that have a U.P.C. or EAN linear component. (This does not affect GS1 Com-

posite symbols with a GS1-128 or GS1 linear component.)

GS1 Composite Code Message Length

Scan the bar codes below to change the message length. Refer to Message

Length Description (page 7-2) for additional information. Minimum and

Maximum lengths = 1-2435. Minimum Default = 1, Maximum Default = 2435.

GS1 Emulation

The imager can automatically format the output from any GS1 data carrier to

emulate what would be encoded in an equivalent GS1-128 or GS1 DataBar

symbol. GS1 data carriers include UPC-A and UPC-E, EAN-13 and EAN-8,

ITF-14, GS1-128, and GS1-128 DataBar and GS1 Composites. (Any applica-

tion that accepts GS1 data can be simplified since it only needs to recognize

one data carrier type.)

If GS1-128 Emulation is scanned, all retail codes (U.P.C., UPC-E, EAN8,

EAN13) are expanded out to 16 digits. If the AIM ID is enabled, the value will

be the GS1-128 AIM ID, ]C1 (see Symbology Chart on page A-1).

If GS1 DataBar Emulation is scanned, all retail codes (U.P.C., UPC-E, EAN8,

EAN13) are expanded out to 16 digits. If the AIM ID is enabled, the value will

be the GS1-DataBar AIM ID, ]e

(see Symbology Chart on page A-1).

If GS1 Code Expansion Off is scanned, retail code expansion is disabled, and

UPC-E expansion is controlled by the UPC-E0 Expand (page 7-22) setting. If

the AIM ID is enabled, the value will be the GS1-128 AIM ID, ]C1 (see

Symbology Chart on page A-1).

UPC/EAN Version On

* UPC/EAN Version Off

Maximum Message Length

Minimum Message Length

Honeywell 2020 User Manual

Questions and Answers: