3 - 22
Data Accumulation Mode
Note: Data Accumulation mode has limitations when using multiple scanners to
one base. If a cordless system is being used in "multiple link mode"
where up to 7 scanners are to be connected to one base, some
accumulated or batched scans could be lost if scanners are constantly
being moved in and out of range.
Scan the bar codes below to turn data accumulation (batch) mode on and off. If
data accumulation mode is on, bar code data is stored when the image scanner
is out of range of the base and transmitted once the image scanner is back in
range.
Default = Off.
Data Accumulation Mode On
* Data Accumulation Mode Off
To Next Page
Loading...
Need help?
General
