4 - 20
When the output sequence is
Off
, the bar code data is output to the host as the
image scanner decodes it.
Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple
symbols with a single pull of the image scanner’s trigger. If you press and hold
the trigger, aiming the image scanner at a series of symbols, it reads unique
symbols once, beeping (if turned on) for each read. The image scanner
attempts to find and decode new symbols as long as the trigger is pulled. When
this programming selection is turned Off, the image scanner will only read the
symbol closest to the aiming beam.
Default = Off.
Required
On/Not Required
*Off
To Next Page
Loading...
Need help?
General
