E
3
Point Gas Monitor Technical Manual
Introduction
1
Introduction
E3Point derives its name from: Energy Management, Efficiency, and Economic
value in gas detection.
E
3
Point is an important part of toxic or combustible gas detection system that
combines a gas sensor (electrochemical or catalytic type), a control unit, and a set
of outputs (such as 4-20 mA current loop, buzzer and relays). The polycarbonate
housing is resistant to rust, dents and corrosion.
There are 3 monitor models in the E
3
Point family: Standalone, Remote and
Network. The Standalone monitor provides the full control unit, with a built
in sensor and is capable of accepting one additional Remote sensor. This
configuration allows the E
3
Point to detect two gases in two separate locations.
The E
3
Point Network platform supports different protocols over an RS-485 link,
such as Modbus or BacNet MS/TP master. It is well suited for commercial use in
parking garages and mechanical rooms. It is intended for connection to the 301-C
or AA96D series contollers.
Installation is both economical and efficient because it is achieved in 3 easy steps
(mounting, wiring and power-up). Units are shipped with a Quick Start Guide to
support proper installation.
Restricted Materials Table for China RoHS
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
