Honeywell luminAXS Series User Manual

39
Mounting and Connection Instructions Reader series "luminAXS"
7.1. Manual address allocation via central control unit4
Enter the serial number of a new plus the desired address when programming the centralreader
control unit. The transmits the serial number plus the address to the . If thecontroller reader
received serial number the number defined in the reader, readercorresponds with the stores the
address.
Programming
Enter serial
number
of the operating unit
plus adress
EU
Panel
Serial number
+ address
Serial number
+ address
The address allocation mode must be
activated.
Hold an MIFARE data carrier in the reading
range. The now transmits thereader serial
number to the . Thecontroller controller
allocates a free address to this number and
transmits the number plus theserial
address back to the . After a briefreader
interval, the stores the addressreader
permanently.
Acknowledgement: After approx. 1 sec.
the LEDs indicate the allocated address
(see 7.1.3).
Serial number
Serial number
+ address
EU
Panel
allocates a free
address to the
numberserial
7.1. Automatic address allocation with data carrier5
7.1.6 Manual address allocation via IQ DeviceInstaller and configuration tool usb
Set up according to Sect. 4.2.
Enter the address in the configuration mode. The address is stored in the reader.
A: !TTENTION A plausibility check is not possible
The address is stored in the reader.
If the reader is later connected with the EU/control panel, the entered address is then sent to the
EU/control panel together with the reader serial number and stored there.
The address can now be confirmed in the display mode (see 7.1.3)

Honeywell luminAXS Series Specifications

General

Brand	Honeywell
Model	luminAXS Series
Category	Card Reader
Language	English