Honeywell MCT404 User Manual

8. Appendix A: Application Notes
8.1. Application Notes
Revision 3 MC Toolkit (MCT404) User Manual 151
Provisioning Devices
 Field device Access Points (FDAP) and
Field Devices (FD) are provisioned before
they can join ISA100 network
 How to provision PFDAP/FD:
 Launch the Provisioning software in the
PD
 Click “Provisioning”
 Point the IR port of the PD at the IR port
on the FDAP/FD to be Provisioned
 Click on the “Provision a Device” button
on the PD
 Security credentials will be transferred to
the FDAP/FD through the IPR port
 PD’s display a message indicating
whether provisioning was successful
TX Power Setting
Transmitters shipped from the factory will have its Transmitter Power (TX) value set according to its
Model Number and this value is consistent with those values given in Table 7-4.
The TX Power setting may be changed via the Authentication Device when a special application (app) is
installed. This app is considered to be Honeywell sensitive material and is made available only to the
qualified Professional Installer.
Due to radio approval body regulations, changing the TX Power setting is only available if the
professional installer option has been explicitly enabled on your Authentication Device.
WARNING:
The Transmitter must be Professionally Installed in accordance with
the requirements specified in this document. Only the specified
power settings, antenna types and gains and cable lengths
(attenuation) as outlined in this document are valid for Transmitter
installations.
Maintenance
The IR Port will show LRV, URV and other configuration information.

Honeywell MCT404 Specifications

General

Brand	Honeywell
Model	MCT404
Category	Cell Phone
Language	English