ID2000 Series Operating Manual
Non-latched Input Operation
40997-434-000-4, Issue 4
May 2010
5 Non-latched Input Operation
This function enables the use of a remotely-placed switch
to switch on, temporarily, certain outputs without the need
for access to the panel. The function is only available if a
remote switch is connected to a loop module which has
been configured as an AUXILIARY type input, and this
has been linked to specific outputs in the Control Matrix.
See the ID2000 Series Panel Configuration Manual
(997-435-XXX) for details on how to configure this option.
Operate the switch as indicated to cause the sounders
or other outputs to operate in the pre-programmed
pattern. Release the switch to switch off the outputs.
Normally there will be no indication at the panel of these
operations. However, some installations may be
configured so that the text display shows the last such
operation in a format similar to that used for other events.
The displays with the switch referred to being still ON or
OFF are shown below. No other indication is shown on
the panel.
(system status) (date) (time)
SET: (module description) AUX
(system status) (date) (time)
CLEAR: (module description) AUX
To Next Page
Loading...
Need help?
General
