12 RP2/RP4 User Guide
Media Types and Settings
5. After updating the New Value column, click the Send button to send this
change to the printer.
6. Allow 30 seconds for the printer to reset.
If you have issues with media registration after sending these settings to the
printer, refer to Calibrate the Media on page 27.
Media Type
Gap Label Notch Edge Notch Center
Reflective
(Black Mark)
Continuous
Sensor Type
Gap Not Supported Gap
Black Mark (Top
or Bottom)
Continuous
Label Length
(set value)
Setting Description
Continuous Label Length
(1/100 inch)
Distance the printer will advance after pressing the Media Feed
button. Distance is measured in 1/100 inch, so 1000 = 10 inches.
Label Width (1/100 inch)
200 = 2 inch media
300 = 3 inch media
400 = 4 inch media
Maximum Label Length
(1/100 inch)
Distance must be greater than the length of your media. Distance is
measured in 1/100 inch, so 1000 = 10 inches.
Sensor Type
Gap = labels with gap
Continuous = media with no gap
Reflective = labels with Q-mark or black mark
To Next Page
Loading...
Need help?
General
