RP2/RP4 User Guide 27
CALIBRATION
Calibrate the Media
The printer is factory-calibrated for operation with most media types (both gap and
reflective). Try your media without performing any calibration adjustments first to
determine if the factory settings are compatible. Only perform the calibration
adjustments if you are experiencing media-registration issues.
Note: The battery should be charged to 50% or more before starting media calibration.
The Quick Media Calibration should be performed first. If it fails to detect the start
of each label properly, proceed to Manual Media Calibration. Install media in the
printer before calibrating it.
Note: Once you have calibrated the printer, you can save this configuration and share it with
other users or printers. See Configuration Files beginning on page 31.
Quick Media Calibration
1. Turn the printer on. If using a USB interface, connect it to the computer using
the USB cable.
2. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
3. In the Printer Information column, click on Sensor Calibration.
To Next Page
Loading...
Need help?
General
